Troubleshooting - Advel 74101 Manual De Instrucciones

Troubleshooting

S Y M P T O M P O S S I B L E C A U S E
Tool reverses Worn thrust bearing or thrust washers Replace
before Insert Dirty insert threads
is Placed Worn drive screw
Lack of lubrication on drive screw
(Standard Nutserts only)
Thrust spring not fitted
Clutch torque setting too low
Insufficient pressure/volume of air
Tool runs slowly Insufficient air pressure
Incorrect bore of hose
Insufficient air volume
Contaminated air supply
Tool fails to start Tool not properly lubricated
Restricted air pressure/volume
Tool runs Insufficient air supply
permanently
in reverse mode
Tool runs Push rods/needle roller missing
permanently
in forward mode
Inserts not Torque setting too low
pulling up Insufficient air pressure/volume
Inserts out of grip
Lack of lubrication on insert
Lack of lubrication on drive screw
(Standard Nutserts only)
Insert thread restricted
Drive screw thread worn
Incorrect insert/drive screw
Other symptoms or failures should be reported to your local Avdel authorised distributor or repair centre.
22
R E M E D Y
Change batch of inserts
Replace
Lubricate drive screw properly
Fit thrust spring
Adjust to correct setting
Check air supply/fittings
Adjust air pressure at base of handle
5 -6.3 bar maximum.
Ensure bore of hose is 10mm
minimum
Ensure there is no restriction in the
air supply or connections
Lubricate as per instructions
Lubricate then depress trigger
several times
Ensure there is no restriction in
the air supply
Adjust air pressure/volume
Replace where necessary
Adjust to correct setting
Adjust air pressure/volume
Select correct insert
Change batch of inserts
Lubricate drive screw correctly
Change Inserts
Replace drive screw
Replace with correct insert/drive
screw
PA G E R E F
9
9
9
15
5
5
7
5
11
11
5
5
20
15
5
9
9
continued overleaf