Safety Instructions - Urrea 2474 Manual De Usuario

E N G L I S H

SAFETY INSTRUCTIONS

• Steel and other materials
can shatter, so always
use personal protective
equipment;
work gloves, protective
eyewear, security boots
and that complies with
the appropriate
code when operating the
press.
• If you detect anything
that may
imminent
failure, stop using the
press immediately
inspect it thoroughly.
• Bolt the press to the floor
if it is to be used on bulky or unstable
items. Ensure that every workpiece is
center-loaded and secure.
• Always position the press against a
wall. If the press is situated in the open
workshop, it is essential that a guard be
placed at the rear of the unit. This will
prevent injury to bystanders in the event
of the work piece ejecting suddenly.
• DO NOT use press to compress springs or
any other item that could disengage and
cause a potential hazard.
• Use a qualified person to maintain
the press in good condition. Keep it
clean for best and safest
performance.
•
t
rated capacity.
•
force to a workpiece and
always use the pressure
gauge
determine the applier load.
•
purpose for which it is
intended. DO NOT use it
for any other purpose it is not designed
to perform.
• Do not introduce any part of the body in
the work area.
• Never wear baggy clothes, ties, watches,
4
heavy-duty
safety
indicate
structural
and
DO NOT exceed the
Never apply excessive
to accurately
Use this press for the
rings, chains, etc. when using the press.
• Long hair should be tied up.
• DO NOT operate the press when you are
tired or under the influence of alcohol,
drugs or any intoxicating medication.
• DO NOT allow untrained people operate
the press.
• Keep children and unauthorized people
away from the work area.
• Keep proper balance and footing, do not
over-reach and wear nonskid footwear.
• Only use this press on a surface that is
stable, level, dry and not slippery and
capable of sustaining the load.
• Keep the surface clear, tidy and free
from unrelated materials and ensure
that there is adequate
lighting.
• Inspect the press before
each use.
• DO NOT use if bent,
broken, cracked, leaking
or otherwise damage.
• Check to ensure that all
applicable bolts and nuts
are firmly tightened.
• DO NOT make
modifications to the press.
• DO NOT use brake fluid or any other
improper fluid and avoid mixing different
types of oil when adding hydraulic oil.
Use oil HL or HM.
• DO NOT expose the press to the rain or
any other kind of bad weather.
• Repair by qualified persons.
PLEASE KEEP THIS INSTRUCTION MANUAL
SAFE FOR FUTURE USE.
WARNING:
The warnings, cautions and instructions
discussed in this manual cannot cover all
conditions and situations that may occur. It
must be understood by the operator that
common sense and caution are factors
which cannot be built into this product,
but must be supplied by the operator.
ASSEMBLY
Use the exploded drawing as your guide
any