Clearing A Jam - Paslode T250-F16 Serie Manual De Instrucciones

TOOL OPERATION -
continued
MOVE UP
TO INCREASE
DRIVE DEPTH
MOVE DOWN
TO DECREASE
DRIVE DEPTH
SOCKET HEAD
CAPSCREW

Clearing a Jam

An occasional problem you may encounter is a
jammed fastener. Because of the unique design
of the tool, clearing a jammed fastener is easy:
1. Disconnect the air supply.
2. Pull the latch, releasing front guide. Pivot front
guide forward.
3. Clear jam, and push driver blade back up to its
normal position.
4. Close front guide and latch it. Check that the
work contacting element moves freely.
WORK
CONTACTING
ELEMENT
Turn
adjustment
wheel in either
direction
clearing a jam continued
Precision Placement Driving - (Orange Trigger)
Grasp the tool handle firmly and hold the bottom of
■
the work contacting element firmly against the work-
piece until it is completely depressed.
Squeeze the trigger to drive the fastener.
■
Lift the tool from the workpiece.
■
Repeat the procedure for the next fastener.
■
Successive (Bounce) Driving - (Orange Trigger)
Grasp the handle firmly.
■
Squeeze the trigger and move the tool along the
■
workpiece with a bouncing motion, depressing the work
contacting element at the points where you want to
insert a fastener.
Keep the trigger depressed and continue to bounce
■
the work contacing element against the workpiece,
positioning the tool above as carefully as possible.
When the desired number of fasteners have been
■
release the tool trigger to avoid unintentional fastener
discharge.
Sequential Operation - (Silver Trigger)
The sequential operating kit prevents successive or
"bounce" driving.
Depress the work contacting element and hold it
■
against the work surface before pulling the trigger.
After each fastener is driven, completely release
■
the trigger and lift the tool from the work surface.
6