Technical Features - Cherubini TDS GOLD Serie Manual De Instrucciones

SHORT-TERM SETTING OF A REMOTE CONTROL
This function makes it possible to store a remote control temporarily, for example, with the
purpose of setting the limit switches during assembly in the factory. A later fi nal saving
of the remote control will be possible using the appropriate command sequence (see:
"SETTING THE FIRST REMOTE CONTROL"). The operations described below can be carried
out only when the motor has just come out of the factory or after a full memory clearing
(see: "FULL MEMORY CLEARING"). The motor makes the following operations possible
only within the time limits described in order to make sure that the short-term setting is
used only in the installation or factory setting phase and not during daily use.
Power up the motor, make sure that no other motors having an empty memory are
powered up in the same operating range.
Within 30 seconds after start, press the B and C buttons simultaneously until the motor
gives a confi rmation signal.
The remote control will remain stored for 5 minutes, while the motor is powered up.
After 5 minutes or when no voltage is supplied to the motor, the remote control will be
cancelled.
T1: remote control to be stored
B
GB
* The degree of protection IP55 between wire/tube and wire-lead can be maintained by correct installation only.
SPECIAL FUNCTIONS
C
+
T1

TECHNICAL FEATURES

Power supply
Power consumption
Carrier frequency
Security coding system
Modulation
Max number storable transmitters 15
Motor maximum power
Operating temperature
Weight
Dimensions
Degree of protection
230 V AC
2 W
433,92 MHz
Rolling code
AM/ASK
500 W
-10°C +55°C
300 g
120x80x50 mm
IP55*
32