Battery Handling; Transport And Storage - Husqvarna QC 330 Manual De Instrucciones

WARNING! Do not use the battery
!
charger close to corrosive or flammable
materials. Do not cover the battery
charger. Pull out the plug to the battery
charger in the event of smoke or fire.
Risk of fire.
• Use the battery charger only when the surrounding
temperature is between 5 °C (41 °F) and 40 °C (104
°F). Use the charger in an environment which is well
ventilated, dry and free from dust.
Do not use:
• a faulty or damaged battery charger
• the battery in the battery charger outdoors.
Do not charge:
• or never use a faulty, damaged or deformed battery.
• the battery in the rain or in wet conditions.
• the battery in direct sunlight.
Operation
WARNING! Risk of electric shock and
!
short circuiting. Use approved and intact
wall sockets. Make sure that the cable is
not damaged. Replace cable if it appears
to be damaged in any way.
Connect the battery charger
• Connect the battery charger to the voltage and
frequency specified on the rating plate.
• Use provided cable with specific coil
• Always use residual current device (RCD) when using
battery charger.
• Put the electric plug in a earthed socket-outlet. The
LED on the battery charger flashes green once. (4)
Connect the battery to the battery
charger.
The battery must be charged before using it the first time.
The battery is only 30% charged when delivered.
NOTE!
During charging monitoring the charging process and
never leave the battery in the charger when charging is
complete.
• Put the battery in the battery charger. Make sure that
the battery is connected to the battery charger. (1), (2)
• The green charging light on the charger is lit when the
battery is connected to the battery charger. The
battery will not be charged if the battery temperature
is over 50 °C (122 °F). In that case the battery charger
will actively cool down the battery. (4)
• When all LEDs are lit the battery is fully charged. (7)
4 – English

BATTERY HANDLING

•
•

Transport and storage

•
•
•
•
•
Maintenance
Make sure the battery and battery charger are clean and
that the terminals on the battery and the battery charger
are always clean and dry before the battery is placed in
the battery charger.
Keep the battery guide tracks clean. Clean plastic parts
with a clean and dry cloth.
Fault codes
Troubleshooting the battery and/or the battery charger
during charging.
(5), (6)
•
Disposal of the battery, battery charger
and machine
Symbols on the product or its packaging indicate that this
product cannot be handled as domestic waste. It must
instead be submitted to an appropriate recycling station
for the recovery of electrical and electronic equipment.
When the battery is recharged the battery charger will
stop charging. (switch to stand by). There are no
restrictions on how long a battery can remain in the
charger. Recommended is to remove the battery from
the battery charger when the battery is recharged.
Pull out the plug. Never jerk the power supply cable to
disconnect it from the wall socket. (3)
Store the equipment in a lockable area so that it is out
of reach of children and unauthorized persons.
Store the battery and the battery charger in a dry,
moisture-free and frost-free space.
Store the battery where the temperature is between 5
°C (41 °F) and 25 °C (77 °F) and never in direct
sunlight.
Store the battery charger only in an enclosed and dry
space.
Be sure to store the battery separate from the battery
charger.
Possible
LED display
faults
Error LED Temperature
flashing deviation.
Cell
difference
Error LED is lit
too much
(1V).
If the LED on the battery charger is lit solid red, the
battery charger requires a service. (5)
Possible action
Use the battery in
surroundings where
temperatures are
between -10 °C (14
°F) and 40 °C (104
°F).
Contact your service
agent.