Before You Start; What's In The Box; Before Using The Remote Control; Replace The Battery - Pioneer XW-NAS3 Manual De Instrucciones

01

Before you start

Chapter 1:
Before you start

What's in the box

Please confirm that the following accessories
are in the box when you open it.
• Remote control
• Remote control holder
• Lithium battery (CR2025)
• Power cord
•
Cleaning cloth
• Operating instructions (This document)

Before using the remote control

The remote control is shipped already set in the
remote control holder.
The battery supplied with this unit is stored in
the battery casing.
• Remove the protective seal from the
battery casing.
When you notice a decrease in the operating
range, replace the battery (see below).
6
En

Replace the battery

When replacing the battery, use a
commercially available Lithium CR2025
battery.
3
1 Push the release tab to the left to open
the battery casing.
2 Pull out the battery casing.
3 Remove the battery from the casing.
4 Place a new battery in the casing.
Make sure the  side of the battery is facing up
when you place it in the space provided.
Caution
When using lithium batteries, please observe
the following:
• There is danger of explosion if the battery is
incorrectly replaced. Make sure to replace
only with the same or equivalent type
recommended by the manufacturer.
• Dispose of used battery cells immediately
after replacement. Keep away from
children.
• If swallowed, please contact a doctor
immediately.
• Lithium batteries may present a fire or
chemical burn hazard if misused. Do not
disassemble, heat above 100 °C, or
incinerate.
1
1
2