Adjusting The Footplate; Adjusting The Pendulum Stroke; Use; Switching On And Off - Parkside PSSA 20-Li A1 Manual Del Usuario

♦ Let go of the quick-release chuck
returns to its initial position . The saw blade
is now locked .

Adjusting the footplate

RISK OF INJURY!
► Always switch the appliance off and remove
the battery before carrying out any work on
the appliance .
♦ Adjust the footplate
depth .
♦ To do so, undo the locking lever
the footplate to the corresponding position .
♦ Lock this position by closing the locking lever

Adjusting the pendulum stroke

♦ You can use the pendulum stroke switch
to adjust the pendular movement of the saw
blade . You can achieve fine, clean-cut edges
without pendulum movement (setting "0") .
Deactivate pendulum movement when working
on thin workpieces . You can achieve an increas-
ingly fast work rate if the pendulum stroke is
activated (setting "I") .
■ 52 │ GB │ MT
so that it
according to the cutting
and move

Use

Switching on and off

Switching on:
♦ First press the safety lock-out
ON/OFF switch
safety lock-out
Switching off:
♦ Release the ON/OFF switch

Adjusting the rotational speed

Press the ON/OFF switch
Increasing the pressure increases the speed .
NOTE
► The integrated motor brake ensures rapid
stoppage .

Guiding the sabre blade safely

To adapt to the workpiece and for safe placement,
the footplate can be swivelled . It must always be
in contact with the workpiece when the appliance
is running .
.

Practical advice on sawing

♦ Check the material to be worked to make sure
that all foreign objects have been removed,
e .g . nails, screws, etc .
♦ Ensure that the ventilation slits
covered .
♦ Switch the appliance on before moving it
towards the material to be worked .
♦ Switch the appliance off immediately if the saw
blade jams .
Open up the sawn gap using a suitable tool
and pull out the sabre saw .
■ Use the appropriate saw blade
rate for the material to be worked .
■ Saw blades optimised for your sabre saw are
available from retail stores in different lengths
for various purposes .
■ Saw the material at a constant speed .
and then the
. Afterwards, release the
.
.
lightly for a low speed .
are not
and stroke
PSSA 20-Li A1