Water Connection; Dismantling The Inlet Hose; Positioning The Drain Hose - Avanti W789SA Manual De Instrucciones

Water Connection

For normal kitchen-sink tap only use the inlet hose with cold water inlet.
Connect the inlet hose to the male hose thread adapter by turning it clockwise to be fixed tightly.
Make sure to insert the rubber ring enclosed. Then connect tightly to your sink.
Note:
Some faucets may require you to also use the female hose thread adapter between the male
adapter and your sink as shown below. Make sure the rubber ring is inserted and connect to
your sink.
If water leaks from faucet connection or washer connection, turn off water and
tighten fully using a wrench. Be careful not to over tighten and damage water
connection. Turn on water supply and make sure no leaks are present

Dismantling The Inlet Hose

Dismantling the hose directly may cause water to splash due to the possible high water pressure in
the hose, even after the faucet has been turned off. Please take off the hose as per following steps,
even if the faucet is closed:
?
Turn off the faucet.
?
Turn on the power and let the machine run for about 5 seconds then turn
it off.
?
At the faucet side press down the clip of the detachable connector, and
pull off the inlet hose, at the machine side remove the nut.
Note: If the washing machine is frequently used, it is not necessary to dismantle
the inlet hose to avoid possible damage to the screws .

Positioning the Drain Hose

Connect the drain hose to the water outlet of the washing machine then fasten it
with a pinchcork. Since only up drainage is available, drain hose can be hung in
the basin or bathtub.
NOTE: The highest point of the drain hose must be in the height of 0.7 -1.2m
above floor level, otherwise, the washer cannot work normally.
11
.
CONNECTING
NUT