Parts - Igloo Kegorator Manual De Instrucciones

PARTS

Read all instructions carefully before assembling the KEGORATOR
IMPORTANT! Stand the KEGERATOR
hours before plugging into an electrical outlet. This will allow the coolant
in the refrigeration unit to stabilize before turning on the power.
If still unsure whether your KEGORATOR™ has been properly assembled,
it is recommended that you contact customer service, or a qualified
installer, such as a brewery or wherever kegs are sold.
Washers / Beer Line Adapter Parts
NOTE: Most washers are already attached to the KEGORATOR
are included in a plastic bag. Refer to the parts diagram and corresponding
part numbers to understand where each washer / extra parts belong.
Body Seal Coupler
Washer (38 mm)
(Part 5)
Tap Tower Washer
(24 mm)
(Part 1)
CO 2 Directional
Washer
(Part 5)
Metal Washer
Qty. 2
(Part 11)
in an upright position for 8-10
TM
Probe Seal Coupler
Washer (22 mm)
(Part 5)
Spigot Handle Washer
(15 mm)
(Part 2)
Backflow Stopper
(Part 5)
Tap Tower Washer
(Part 1)
. Extra parts
TM
Inner Probe Seal
Coupler Washer
(23 mm)
(Part 5)
Tap Tower Spigot Regulator High Pressure
Washer (13 mm)
(Part 3)
Hose Clamps
(Part 4)
.
TM
Top Coupler
Washer (20 mm)
(Part 5)
Washer (18 mm)
(Part 6)
CO 2 Hole Plug
(Exterior Cabinet)
6