PORTAMIX Mega Hippo Instrucciones De Uso página 4

MIXING M0TOR SPECIFICATIONS
Before starting the machine check the
correspondence between voltage and frequency
according to the data mentioned on the
identification plate. Voltage differences from
+6% and –10 % are allowed.
Recommended minimum cross sections and maximum cable lengths
Mains voltage
110V
230V
SWITCHING ON AND OFF
Switching on:
Plug motor into the power source
Set the in line circuit breaker
Press the on/off switch on motor
CHANGING GEARS
The machine is equipped with a mechanical three-speed
gearbox. Select the required speed by turning the knob
to the desired gear. Only change the speed when the
machine is not running.
Attention:
Never apply force when changing gear.
Change the gear only when the motor
is stopped.
Never use tools, such as hammers
or pliers to change the gear.
04
10m cable 30m cable
1.5mm* 2.5mm*
1.5mm* 2.5mm*
DANGER—SAFETY: Keep hands and other objects well clear of the mixing shaft and canister when mixer is in operation or serious injury could result.
The motor is made in protection class II.
Only use extension cables with a sufficient cross-
section. A cross-section which is too small could
lead to an excessive power loss and to an
overheating of motor and cable.
*Cross section in sq. mm
Switching off:
Release the on/off switch
This will trip the inline circuit breaker
eliminating accidental start-up
Speed
One 160 RPM
Two 290 RPM
Three 410 RPM