LG WT22WT6H Manual Del Propietário página 51

3
Push the adapter onto the end of the tap
so that the rubber seal is connected to be
watertight. Tighten the 4 fixing screws.
4
Push the inlet hose c vertically upwards
so that the rubber seal within the hose can
adhere completely to the tap and then tighten
the hose by screwing it to the right.
Connecting One Touch Type Hose to Tap
Without Thread
1
Unscrew the adapter ring plate d and loose
the 4 fixing screws.
2
Remove the guide plate e if the tap is too
large to fit the adapter.
3
Push the adapter onto the end of the tap
so that the rubber seal is connected to be
watertight. Tighten the 4 fixing screws and the
adapter ring plate.
4
Pull the connector latch plate f down, push
the inlet hose onto the adapter, and release
the connector latch plate. Make sure the
adapter locks into place.
EN
13