Milwaukee 2120-20 Manual Del Operador página 3

ASSEMBLY
WARNING
the charger specified for the battery. For specific
charging instructions, read the operator's manual
supplied with your charger and battery.
Inserting/Removing Battery Pack
Unlatch the battery door and open
to access the battery bays.
Insert a battery pack by sliding bat-
tery pack into a battery bay. Insert
the battery pack until the battery
latches lock.
Close and latch the battery door.
To remove a battery pack, press in
both battery latches and slide the
battery pack out of the battery bay.
NOTE: Always ensure the battery door gasket is clean
and clear of dirt and debris. Close battery door latch
securely to ensure water cannot enter the battery
compartment.
WARNING
injury, do not look directly into the light when the
light is on.
To reduce the risk of injury, always fully extend and
lock legs into position before raising the poles.
Light may tip and cause injury.
To reduce the risk of injury, keep hands clear of
the housing area when collapsing the extension
poles. Head may descend rapidly, pinching hands
and fingers.
Extending/Collapsing the Legs
Always extend and lock the legs before raising the
poles.
1. To extend the legs, stand light on end and press
the leg release button.
2. Rotate the legs out to the standing position or
stabilizing position. Ensure the legs lock into place.
3. To collapse the legs, press the leg release button
and rotate the legs back to the closed position. Keep
hands clear of the legs as they collapse.
Extending/Collapsing the Extension Poles
1. To extend the poles, position and lock the legs.
2. Pull up on the extension release
bracket and rotate the extension to
the desired angle. Ensure the
bracket locks into a detent.
3. Press the top extension button and
raise the head. Extend the pole to
the desired height.
4. If more height is needed, repeat
with the lower extension.
5. Rotate the head to the desired
position.
Recharge only with
To reduce the risk of
Use the stabilizing position
when positioning
the light over a
ditch or hole
2
6. To collapse the poles, press the extension buttons
and slide the poles back into position. Keep hands
clear of the brackets as the poles collapse.
7. Rotate the head into the
"protected" position or "use"
position, then lift the exten-
sion release bracket and
rotate the extension to the
closed position.
To learn more about the ONE-KEY functionality for
this tool, please reference the Quick Start guide in-
cluded with this product or go to milwaukeetool.com/
One-Key. To download the ONE-KEY app, visit the
App Store or Google Play from your smart device.
WARNING
injury, do not look directly into the light when
the light is on.
1. Insert battery pack(s). Close and latch the battery
door.
2. Press the Power
3. Press the - and + buttons to cycle through High,
Medium, and Low.
NOTE: The light will default to the selected brightness
the next time it is turned on.
4. Press the Power
NOTE: When multiple batteries are installed, the sec-
ond battery pack inserted will begin operation when
the first pack inserted has reached end-of-charge.
WARNING
product as shown below. It may be overturned.
1
3
Head rotated out for "use"
position. Rotate 180° for
"protected" position.
ONE-KEY™
OPERATION
To reduce the risk of
Using the Light
button to turn on the light.
button to turn the light off.
Do not position the