English
Hot water can drip out of accessories
while you are detaching them. Do not de-
tach accessories while steam is being di-
scharged danger of scalding!
2.3 Filling up with water
Do not add pour any detergents or other
additives into the boiler.
2.4 Switching the cleaner ON
Do not switch the cleaner on if there is no
water in the boiler, otherwise it could over-
heat. As a safety measure, the cleaners
heater switches off automatically and the
low-water warning lamp (A6 illuminates. In
order to be able to use the cleaner again,
wait approx. 10 minutes for it to cool down
and then fill the boiler with water (see 2.6
Refilling with water).
2.5 Regulating the volume of steam
4
2.6 Refilling with water
Note: When the water in the boiler has been
used up, the low-water warning lamp (A6) will
illuminate. The safety cap (A2) cannot be opened
while there is any pressure at all in the boiler.
If the cleaner has been in continuous use
for a long time, the safety cap (A2) may be
hot!
If the boiler is still hot, there is a risk that
water will be squirted back while it is being
poured into the boiler and cause scalding.
2.7 Switching the cleaner OFF
Fig. 2:
Pull out the accessory plug