Edirol Canvas SD-20 Manual Del Usuario página 28

Getting connected and installing drivers (Windows)
7
Connect the SD-20.
1. Set the computer switch of the SD-20 to USB.
2. With the SD-20's power switch turned off, connect it to the AC
adaptor.
3. Plug the AC adaptor into an AC power outlet.
4. Use the USB cable to connect the SD-20 to your computer.
5
Set the SD-20's power switch to the ON position.
fig.2-20_30
6
If you are using Windows 98, an
Insert Disk dialog box will
appear.
Click [OK].
fig.2-21a_40
7
The New Hardware Found
dialog box will appear.
In the "Copy files from" area, type
"D:\DRIVER\USB_ME98" and
click [OK].
8
Once the driver has been installed, New Hardware Found dialog box will
close.
In the SETUPINF dialog box, click [OK]. The SETUPINF dialog box will
close.
Next, you need to make the driver settings.
(-> Settings and checking (p. 39)
28
Even if you will normally
be using the SD-20 with
BUS power, please use the
AC adaptor while you are
installing the driver and
making settings.
This unit is equipped with
a protection circuit. A brief
interval (a few seconds)
after power up is required
before the unit will operate
normally.
If you are using Windows
98 and the Insert Disk
dialog box dose not
appear, please read The
"Insert Disk" dialog box
does not appear (p. 235).
If the New Hardware
Found dialog box does not
appear, re-install the
driver using the same
procedure as described in
The "Insert Disk" dialog
box does not appear (p.
235).