Storage; Troubleshooting - Surtek AS612A Manual De Usuario

counter-clockwise to loosen and remove, slide
the cartridge filter off the lid cage (fig.14).
4. To clean the cartridge filter shake or brush
off excess dirt or rinse (from the inside of the
filter) with water, dry completely (approx. 24
hrs) and re-install.
NOTE: If the filter has been used for wet pick
up, it must be cleaned and dried before using
for dry pick up.
EMPTYING LIQUID WASTE FROM THE TANK
(Specified by model)
Your SURTEK wet/dry vacs can be emptied of
liquid waste. To empty, stop the motor and
remove the plug from the wall receptacle. In
AS612A model, remove the draining waste
port tap let the tank to be emptied in the into
the drain. After the tank is completely empty,
re-install the draining port cap in place.
For AS510A, AS506A AS503 models, remove
the power head tilt it and deposit the liquid
waste contents in a suitable drain. Return the
cover to its original position after emptying
the tank. To continue the normal use, plug
the cord into the wall receptacle and start the
motor.
AUTOMATIC SHUT-OFF
The cleaner is equipped with an automatic
shut-off that operates when picking up liquids.
As the level of the liquid rises, an internal
float rises until it seats itself against a seal at
the intake of the motor, shutting off suction.
When this happens, the motor will develop a
higher than normal pitch noise. To continue
use, empty the liquid waste from the tank as
outlined in the previous paragraph.
NOTE: If accidentally tipped over, the vacuum
could close suction. If this occurs, place vac in
upright position and turn switch off. This will
allow the float to return to its normal position,
and you will be able to continue operation.
16
BLOWER FEATURE
This vacuum can be
used as a powerful
blower. To use your
unit as a blower insert
hose end into the top
exhaust port (fig.15).
Clear hose of any obstructions before attach-
ing to blower port. Caution should be used
when using as a blower due to the powerful
force of air when using certain attachments.
WARNING: Always wear eye protection to
prevent rocks or debris from being blown or
ricocheting into the eyes or face, which can
result in serious injury.

STORAGE

Before storing your vacuum cleaner, the tank
should be emptied and cleaned, The power
cord can be wound around the housing of
the unit for convenience. The accessories can
be put on the accessories-holder of the caster
dolly. The cleaner should be stored indoors.

TROUBLESHOOTING

SUCTION WEAKENS OR CLEANER RUNS HOT
Clogged filter: Brush dirt from filter. If condi-
tion continues, change filter.
Air leak: Check all fittings for tight fit (nozzle,
hose, etc.). Check that power head is sealed
properly.
Obstruction in hose of nozzle: Check nozzle,
hose, etc., for obstructions and remove if pres-
ent.
VACUUM DOES NOT RUN
No electricity: Make sure electrical outlet has
voltage. (A qualified electrician may need to
be contacted).
Fig.15