Makita HR4002 Manual De Instrucciones página 5

Ocultar thumbs Ver también para HR4002:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CAUTION:
Use the side handle only when chipping, scaling or
demolishing. Do not use it when drilling in concrete,
masonry, etc. The tool cannot be held properly with
this side handle when drilling.
The side handle can be swung 360° on the vertical and
secured at any desired position. It also secures at eight
different positions back and forth on the horizontal. Just
loosen the clamp nut to swing the side handle to a
desired position. Then tighten the clamp nut securely.
1
2
006315
Side grip
008065
CAUTION:
Always use the side grip to ensure operating safety
when drilling in concrete, masonry, etc.
The side grip swings around to either side, allowing easy
handling of the tool in any position. Loosen the side grip
by turning it counterclockwise, swing it to the desired
position and then tighten it by turning clockwise.
Bit grease (optional accessory)
Coat the bit shank head beforehand with a small amount
of bit grease (about 0.5 -1 g; 0.02 - 0.04 oz.). This chuck
lubrication assures smooth action and longer service
life.
1. Side handle
2. Clamp nut
1
1. Side grip
Installing or removing the bit
2
1
003150
Clean the bit shank and apply bit grease before installing the bit.
Insert the bit into the tool. Turn the bit and push it in until
it engages.
1
2
008057
If the bit cannot be pushed in, remove the bit. Pull the
chuck cover down a couple of times. Then insert the bit
again. Turn the bit and push it in until it engages.
After installing, always make sure that the bit is securely
held in place by trying to pull it out.
To remove the bit, pull the chuck cover down all the way
and pull the bit out.
1
2
008059
Bit angle (when chipping, scaling or
demolishing)
008063
5
1. Bit shank
2. Bit grease
1. Bit
2. Chuck cover
1. Bit
2. Chuck cover
1. Pointer
2
1
2. Change lever
3. Lock button
3

Publicidad

Tabla de contenido
loading

Tabla de contenido