Flash Parameters (Parameter Menu); Setting Procedure For The Flash Parameters - Metz MECABLITZ 58 AF-2 digital Manual De Instrucciones

Setting procedure:
• Press the
F 4.0
flash parameter
MZoom 24
(F=f-stop or P=partial light output) appears on the LC
4,6 m P1/1
display.
+
Para –
• Set the desired value using the
The setting takes effect immediately.
• Press the button
2.1 m P1/32
to the normal view. If the button
Para – +
the display will change back to the normal view after
about 5 seconds.
☞ Aperture and ISO settings do not appear on the LC display in strobe
mode. Strobe mode may not be combined with an operational second
reflector .
122
button (Parameters) until the desired
Para
+
–
/ buttons.
to change the LC display back
is not pressed,

6 Flash parameters (Parameter menu)

For the flash unit to operate correctly, various flash parameters such as the zoom
position of the main reflector, aperture, ISO light sensitivity, etc. have to be adju-
sted to match the camera.
For this automatic data transfer to occur, the flash unit has to be mounted on the
camera, and both devices have to be switched on. In addition, a data exchange
between the camera and flash unit has to be initiated, for which you simply brie-
fly press the shutter release. The maximum range as per the current flash parame-
ters is shown on the display.

6.1 Setting procedure for the flash parameters

When a button is pressed for the first time, the LC display is illuminated.
☞
Depending on the flash mode set, various flash parameters are shown in the
menu: For cameras with digital data transfer, the flash parameters for aperture
(F), lens focal length (Zoom), and light sensitivity (ISO) are automatically set on
the flash unit. The flash parameters for aperture (F) and light sensitivity (ISO)
cannot be changed.
☞ If the camera does not transfer one or more flash parameters to the flash
unit, you will have to adjust these settings by hand.
Press the button (Parameters) until the desired flash parameter (see below)
Para
appears on the LC display.
The following parameters are available: