DSP Control
6.5 Gate interface
Touch the switch in this window, you can engage and disen-
gage the Gate for the selected channel. It will illuminate to
indicate that the Gate has been touched and enabled. The
LCD display shows the Gate setting in real time. Its param-
eters can change by adjusting Threshold, Attack & Release
control directly and use the Parameter Adjust knob to set the
value. Please notice that only if the Gate control has been en-
abled can its parameters be adjusted.
The bar has 3 colors here, which indicate 3 status.
•
Grey- the switch is OFF.
•
Green- the switch is ON, there is signal input and the val-
ue is below threshold level, which means it enables the
gate function.
•
Red- the switch is ON, but gate function not enable.
LIVE 16XL
ENGLISH VERSION
Touch it to set the level at which the gate will open. It can be
set from 0 to -84 dB.
Touch it to set the time for the gate to change from closed to
open, much like a fade-in. It can be set from 0.5 to 200 ms.
Touch it to set the amount of time for the gate to go from
open to fully close. It can be set from 0.01 to 1 second.
Note: A fast release abruptly cuts off the sound once it has
fallen below the threshold,A slower release smoothly changes
from open to closed, much like a slow fade out. If the release
time is too short a click can be heard when the gate re-opens.
p. 33