Programming The Set Points; Rainfall Set Point; Temperature Set Point (Rain/Freeze Sensor Only); Programming Irrigation Modes - Rain Bird WR2 Serie Manual Del Usuario

5. The Sensor is successfully paired to
the Controller Interface when the
"Sensor Indicator / Pairing Status" icon
stops flashing. Once paired, sensor
signal strength and battery life are
communicated via the Controller Interface
icons. Additionally, a blinking light on
the bottom of the Sensor indicates signal
strength for 20 minutes immediately
following successful pairing. These "self
test" features are an indication that your
WR2 Wireless Sensor is operational.
Programming the
Set Points
The WR2 Wireless Sensor allows the contractor
to establish rainfall and temperature set
points appropriate for local environmental
and soil conditions. Alternately, the contractor
may elect to use the "Standard Setting":
temperature 37°F (3°C), rain fall ¼" (6mm) and
"programmed irrigation" mode. The "Standard
Setting" is programmed at the factory and is
active after successful pairing.

Rainfall Set Point

1. Push left or right
2. When the Rainfall
3. Press the left or right
6
WR2 Wireless Sensor • www.rainbird.com/WR2
WR2 user manual (637469-01) EN ESMX FRCA.indd 6
arrow on keypad to
navigate to the Rainfall
Indicator icon.
Indicator icon flashes,
+ –
press the / button
on the keypad to set
programming details.
Each press of the
button adjusts the set
point. Select from six
(6) set points ranging
from 1/8" (3mm) to
1/2" (13mm).
arrow to accept
programming details
and to navigate to
next icon.
Temperature Set Point (Rain/
Freeze Sensor only)
1. Push left or right arrow
2. When the Temperature
3. Press the left or right
Programming
Irrigation Modes
1. Push left or right arrow
2. When the Irrigation
3. Press the left or right
on keypad to navigate
to the Temperature
Indicator icon.
Indicator icon flashes,
+ –
press the / button
on the keypad to set
programming details.
Select one of three
temperature settings:
33°F (0.5°C), 37°F (3°C),
or 41°F (5°C).
arrow to accept
programming details
and to navigate to
next icon.
on keypad to navigate
to the Irrigation Mode
icon.
Mode icon flashes,
+ –
press the / button
on the keypad to set
programming details.
Manually set one of
three irrigation modes.
See Irrigation Modes.
arrow to accept
programming details
and to navigate to
next icon.
2/23/2018 8:09:25 AM