Notes
• When you increase the sound volume, in some cases the back ground noise
may be increased as well. You should adjust the volume accordingly.
• If the handset beeps every second during a conversation and "OUT OF
RANGE" appears on the display, move closer to the base phone; otherwise,
the call will be disconnected after one minute.
• While conversing with an outside caller via the base phone, you can't make a
call with the handset and "BASEPHONE IN USE" appears on the display. If
you press (TALK/ CALL WAITING/ FLASH), you will hear a busy tone.
• When the operation duration exceeds 9:59'59, the display counts from 0:00'00
again.
If the battery becomes weak during a call
The handset will beep every three seconds five times and i and
"BATTERY LOW" appears on the display. Finish your call and charge
the battery pack.
For optimum performance, charge the battery for a full 12 hours.
Note that during the first 10 - 15 minutes of charging, the phone will be
inactive, i.e., unable to make or receive a call.
After this initial 10 - 15 minutes, you may be able to use the phone, but
the battery duration will be very short; thus it is recommended that
you fully charge the battery before the next usage.
Making calls through the speakerphone
Press (SPEAKERPHONE) on the base
phone.
"SPEAKERPHONE" appears on the
display and the display also shows the
operation duration in hours, minutes and
seconds.
The LINE lamp lights up.
Dial the phone number.
To adjust the speaker volume, slide the
SPEAKER VOLUME control.
When you're done talking, press
(SPEAKERPHONE) again.
Notes
• While conversing with an outside caller via the handset, the display on the
base phone shows "HANDSET IN USE" and you can't make a call through
the speakerphone. If you press (SPEAKERPHONE), you will hear a busy tone.
• When the operation duration exceeds 9:59'59, the display counts from 0:00'00
again.
LINE lamp
SPEAKER VOLUME control
(SPEAKERPHONE)
continued
15
Basics
US