Typical Installations - Broan QTXE110SFLT Guia De Instalacion

TYPICAL INSTALLATIONS

Housing mounted to
I-joists.
Housing mounted to joists.
Housing mounted anywhere
between trusses using
hanger bars.
PLAN THE INSTALLATION
1. Choose the
installation
(Can be placed around
and over fan housing.)
location.
The location of
your humidity
sensing
fan is very
important. Use
the following
guidelines for
HOUSING
best operation:
*
Housing mounted
anywhere between
I-joists using hanger bars.
Housing mounted
anywhere between
joists using hanger bars.
Housing mounted anywhere
between trusses using hanger
bars.
INSULATION
FAN
6-IN.
ROUND DUCT *
Purchase 6-IN. ROUND
separately
ELBOW(S) *
• Locate unit above (GFCI protected circuit required) or
within 5 feet of shower head.
• Locate unit away from heating or cooling sources
which can affect humidity levels.
• Do not locate near window. Unit may respond to the
outdoor humidity level.
• Unit must be installed in ceiling to properly sense
moisture.
• Locate unit only on flat ceilings up to 12 feet high for
proper sensing.
• The fan will operate most efficiently when located
where the shortest possible duct run and minimum
number of elbows will be needed.
2. Plan the wiring.
• Plan to supply the unit with proper line voltage and
appropriate power cable. Power cable should be
routed to the switch box first and then to the unit
(See "CONNECT WIRING" on page 3).
• Do not operate this unit with a speed control.
Damage to the sensor unit will result.
• Light or night-light may be installed with a wall-
mounted motion control.
INSTALL HOUSING &
DUCT
1a. Mount
housing
to joist or
I-joist.
Use a pliers to
bend housing
TABS out
to 90 0
housing in
place so that
the housing
tabs contact
the bottom
of the joist.
The housing
ROOF
CAP * mounts with
four (4) screws
or nails. Screw
or nail housing
to joist through
lowest holes in
each mounting
flange, then
through highest holes. NOTE: Mounting to I-JOIST
(shown) requires use of SPACERS (included)
between the highest hole of each mounting flange and
the I-joist.
WALL
CAP *
MODEL QTXE110SFLT
. Hold
(use for mounting to I-Joist)
OR
Page 2
TABS
SPACER
I-JOIST