Broan Elite E60000 Serie Manual De Instrucciones página 5

1. SELECT BLOWER OPTION AND INSTALLATION TYPE
1.1 N -D I
ON UCTED NSTALLATION
For a non-ducted installation, a recirculation kit ANKE60 Series (sold separately) must be installed. For maximum effectiveness, we
recommend installing this kit with a single (internal) blower hood. The kit fits hood from 30-inch width up to 48-inch width. See installation
instructions included with the non-duct kit ANKE60 Series.
1.2 D I
UCTED NSTALLATION
The Broan Elite E60000 Series range hood includes many configurations: Hoods with single or double internal blowers(included with
the hood), or hoods using external blowers. For this last category, the Broan Elite E60000 Series must be installed with in-line blower
models HLB3, HLB6, HLB9 or HLB11, or exterior blower model 331H, 332H, 335 or 336 only. Other blowers cannot be substituted.
(Blowers sold separately).
Plan where and how the ductwork will be installed.
If installing in-line blower, refer to instructions packed with in-line blower and follow steps 1, 2, 3, 4, 6, 10, 12 and up of this manual.
Install proper-sized ductwork, elbows and roof or wall cap for the type of blower you are installing. If using 7" , 8" or 10" round ducts,
use a transition (internal blowers only). Use 2" metal foil duct tape to seal duct joints.
DECORATIVE FLUE
or SOFFIT
HOOD
24" TO 30" ABOVE
COOKING SURFACE
HH0172A
ONE INTERNAL BLOWER
TYPICAL DUCTWORK
DECORATIVE FLUE
OR SOFFIT
HOOD
24" TO 30" ABOVE
COOKING SURFACE
HH0174A
MODEL 331H, 332H, 335 OR 336
EXTERIOR BLOWER TYPICAL DUCTWORK
ROOF CAP
7" or 8" ROUND
OR 3¼" x 10" DUCT
12"
WALL CAP
7" or 8" ROUND
OR 3¼" x 10"
RECTANGULAR
ELBOW
EXTERIOR BLOWER
10" ROUND
DUCT
10" ROUND
12 "
ELBOW
EXTERIOR
BLOWER
332KR
ROUGH-IN KIT
(see page 4)
ROOF CAP
DECORATIVE FLUE
or SOFFIT
HOOD
24" TO 30" ABOVE
COOKING SURFACE
HH0173A
TWO INTERNAL BLOWERS
TYPICAL DUCTWORK
10" ROUND DUCT
(except HLB3, 8'' ROUND DUCT)
IN-LINE BLOWER
24" TO 30" ABOVE
COOKING SURFACE
HH0175A
MODEL HLB3, HLB6, HLB9 OR HLB11
IN-LINE BLOWER TYPICAL DUCTWORK
5
10" ROUND DUCT
WALL CAP
12"
4½" x 18½"
TO 10"
ROUND
TRANSITION
(see page 3)
ROOF CAP
WALL
CAP
HOOD