7. Remove the motor body with the cover from the work bowl.
8. Carefully remove the chopping blade, holding it by the gripping
ridges on the plastic sheath.
ITSELF
.
9. Remove food with a spatula.
Note: Do not operate the food processor attachment
without food contents in the work bowl.
SLICING AND SHREDDING FOOD
The reversible slicing/shredding disc can slice and shred a variety of
fruits, vegetables and cheeses. See Slicing and Shredding Tips on
page 15. Refer to Slicing and Shredding Disc Assembly on page 9.
1. Place the work bowl firmly on a flat, sturdy surface like a counter-
top. Be sure the disc is assembled to use the desired cutting
edge.
2. Insert food in feed tube. Insert pusher. Use light to moderate
pressure to push down on pusher with one hand while using your
other hand to push the Power button on hand blender.
3. Slicing and shredding take only a few seconds. Wait until disc
stops spinning before removing cover.
PUSHER TO GUIDE FOOD THROUGH FEED TUBE. NEVER
USE YOUR FINGERS OR A SPATULA.
4. Unplug hand blender. Remove cover, then the slicing/shredding
disc. To remove it, grasp flat top section of adapter stem and lift
it straight up while holding the work bowl.
WHISKING
1. Insert the whisk attachment into the motor body. (See Assembly
for Whisk Attachment, page 10.)
2. Plug electrical cord into a wall socket.
3. Put the whisk into mixture to be blended.
4. Press and hold the Power button. The hand blender will continue
to run as long as the switch is pressed in. To turn hand blender
off, release the Power button and the motor will stop.
CLEANING AND MAINTENANCE
HAND BLENDER
Always clean the motor body and blending shaft thoroughly after
using. Remove the blending shaft from the motor body. Clean the
motor body only with a sponge or damp cloth. Do not use abrasive
cleaners that could scratch the surface. To clean the blending shaft,
wash by hand in hot water using mild detergent. Be mindful of the
fixed razor-sharp edges.
NEVER TOUCH THE BLADE
ALWAYS USE THE
12