How To Connect Speaker Cords - Yamaha NS-P610 Manual De Instrucciones

How to connect speaker cords

Main/center/rear speakers
Red: positive (+)
Black: negative (–)
3
1
Banana plug
2
Subwoofer (INPUT1/OUTPUT terminals)
Red: positive (+)
Black: negative (–)
2
1
1
2
Banana plug
2
3
1
3
For connections, keep the speaker cords as short as
possible. Do not bundle or roll up the excess part of the
cords. If the connections are faulty, no sound will be heard
from the speakers. Make sure that the + and – polarity
markings of the speaker cords are observed and set
correctly. If these cords are reversed, the sound will be
unnatural and lack bass.
How to Connect:
1
Loosen the knob.
2
Insert the bare wire. [Remove approx. 10 mm (3/8")
insulation from the speaker cords.]
10 mm
3
Tighten the knob and secure the cord.
Test the firmness of the connection by pulling lightly on
the cord at the terminal.
Note
Do not let the bare speaker wires touch each other as
this could damage the speaker or the amplifier, or both
of them.
When using a banana plug
(main/center/rear speakers)
<
U.S.A., Canada, Australia, China and General models
>
only
1
Remove the cover by pulling it toward you.
2
Tighten the terminal knob.
3
Simply insert the banana plug into the terminal.
7
E-