Tools Required; Assembly - Desa 28BN Manual Del Propietário

TOOLS REQUIRED

4

ASSEMBLY

TOOLS REQUIRED
• #2 Phillips screwdriver
• 9/16" Open end wrench
ASSEMBLY
Assemble the heater in the approximate location it will be used to
minimize moving heater once assembled.
1. Position base on floor with open side down.
2. Locate right wrapper and left wrapper. Place one side to base
and secure using 5 screws provided. Repeat for other side (see
Figure 2).
3. Locate center wrapper. The center wrapper is angled at the
bottom and has a hole on either side of the front at the top.
Slide J-clips over holes on open side of center wrapper with
short side to the outside of center wrapper (see Figure 3).
Left
Wrapper
Base
(Front)
Figure 2 - Attaching Left and Right Wrappers to Base
J-Clips
Short Leg of J-Clip
on Outside of Wrapper
Center
Wrapper
Figure 3 - Attaching Center Wrapper to Base Assembly
For more information, visit www.desatech.com
For more information, visit www.desatech.com
Right
Wrapper
Screw
Screw
Base
Base
Angled End Assembly
4. Align holes on center wrapper with holes on left and right wrap-
pers. Using screws provided, attach center wrapper to left and
right wrappers and base from inside the assembly (see Figure 4).
5. Insert back plate up through the base and wrapper assembly
and attach to left and right wrappers with 4 screws provided
(see Figure 5). The back plate will be under the wrapper flanges
as shown in Figure 5.
Figure 4 - Attaching Back Plate
Back Plate
Figure 5 - Back Plate Location
Back
Plate
Screw
Base/Wrapper
Assembly
Back Plate Under
Wrapper Flanges
Wrapper
Flanges
107396-01F