Changing The Diamonds - Husqvarna PG 680 Manual De Instrucciones

Changing the diamonds

As different applications require different selections of
diamond tools, there will be many occasions when the
grinding discs need to be changed.
Following is a guide for this procedure.
Preparation
1. Ensure STOP/RUN switch is in STOP position as
unintentional starting of machine while changing
discs
can result in serious injury.
2. Have a set of gloves ready, as diamonds can get
very
hot during dry grinding applications.
Changing
1. Set handle in upright position (illustrated right).
2. Pull back on handle to lift grinding head off the
ground.
4. Lay machine back on the ground.
5. Put on gloves.
6. Remove grinding disc by slightly rotating disc and
then
pull off (direction that the discs will need to be ro-
tated
will depend on the direction the machine was last
running).
7. Check to ensure all head locks/shear pins are tight.
8. Once new diamonds have been attached, reverse
procedure to lower machine to ground.
9. As new diamonds may be a different height to set
being previously used, re-adjust skirt to ensure
good seal is established with the fl oor.
12
- English
Changing the diamonds