Eddy TBE2 Manual De Uso página 9


Never change the bolt length on the rubber shocks and do not use shims or bushings on top or bottom.
Tampering with these parts may result in accidents and injuries. Periodically verify parts #26 and #50 for
proper operation.
Before using the tool
Check for damaged parts before using the tool. A damaged guard or part should be carefully checked to
determine if it will operate properly and perform its intended function. Check the alignment of moving parts,
binding of moving parts, breakage of parts, mounting and any other conditions that may affect the tool operation.
A guard or other part that is damaged should be properly repaired or replaced by an authorized service center
before using the tool.
Voltage verification
Before connecting the tool to a power source, make sure that the voltage supplied is the same as the one
specified on the nameplate of the tool. A power source with a greater voltage may result in serious injury to the
user as well as damage to the tool. If in doubt, do not plug-in the tool. Using voltage lower than specified is
harmful to the motor.
Page | 9