Installation & Assembly; Unpacking - Surtek HG526 Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1. Fuel tank cap.
2. Fuel tank.
3. Spark plug.
4. Choke lever.
5. Pressure gun.
6. Steel wand.
7. Air filter.
8. Starter cord handle.
9. Fuel valve.
10. Throttle lever.
11. Engine ON/OFF switch.
12. Oil tank with dip stick.
13. Water outlet for pressure hose.
14. Detergent pipe.
15. Pump fresh water inlet (3/4").
16. Thermal relieve valve.
17. Pressure hose 20'
18. Muffler.
INSTALLATION AND ASSEMBLY
Your pressure washer requires some assembly
and is ready for use after it has been properly
serviced with the recommended oil and fuel.
Tool need open-end wrench 10 mm, 14 mm, 17
mm.

UNPACKING

When unpacking check to make sure that all
parts are included. If any parts are missing or
broken, please call our distributor.
ASSEMBLY INSTRUCTIONS
1. Attach hose holder to the frame with bolts
and nuts.
2. Attach the gun hook to the frame with bolts
and nuts.
16
3. Connect the garden hose with the inlet con-
nector of pump.
4. Assemble the spray gun with the metal
wand. Pull back the rubber piece to expose the
threaded fitting. Then, screw the two pieces
together and move the rubber piece back.
5. Connect one end of the pressure hose to
pump outlet, and secure the plastic nut.
6. Connect the other end the pressure gun, and
fasten the plastic nut.

Publicidad

Tabla de contenido
loading

Tabla de contenido