DM 2610039151 01-16_3D40 1/7/16 9:33 AM Page 34
PROBLEM
Extruder head building off
center.
PLA is not extruding or sticking
to the build tape properly.
Print Studio software froze
during use or computer froze.
Dremel 3D40 froze before my
object started.
Support material does not
break away during cleaning and
results in decreased quality of
the final object.
Spaghetti mess at end of build.
Part only built halfway.
No filament coming out.
Extruder will not home.
Stringy or fraying plastic layers
on steep overhangs.
3D40 will not find my Wi-Fi
network.
Troubleshooting
CAUSE
Dremel 3D40 has lost track of
the extruder head's exact
location and is failing to build.
This can be caused by the build
platform not being leveled with
the extruder head.
Sometimes software isn't as
smart as you are and locks up.
Dremel 3D40 may have
received conflicting commands.
Orientation of the part is not
optimized.
A layer of your object did not
stick properly, model was saved
with minimal surface area
contacting the build platform,
or object was built floating
above the build platform with
no support selected.
Filament ran out.
Filament clogged during build.
Clogged extruder.
Object overhangs are too far
apart or too steep (<45 degree
angle).
Printer too far from wireless
router.
34
CORRECTIVE ACTION
Sending the extruder head to the
home position will recalibrate the
Dremel 3D40. Cancel your object,
clear build platform, send the
extruder head to the home position,
and restart the object.
Leveling the build platform will align
the extruder head and ensure a better
object quality. Cancel your object,
clear build platform, level the build
platform, and restart the object.
Save any open files if possible and
either restart the Print Studio
software or your computer.
Turn power switch off, wait 30
seconds, and turn power switch on.
Reorient the position of the 3D file in
Print Studio to minimize the support
material or place the support material
on a non-critical surface.
Use the preview feature in Print
Studio to see the first layer height and
position. Build with supports when
necessary.
Replace filament and resume build.
See "No filament coming out".
Contact customer service.
Contact customer service.
Build with supports.
Reposition 3D40 to be closer to your
router.
Connect to network with Ethernet