Canceling A Cycle; Changing A Cycle Or Setting - Sears Kenmore ULTRA WASH 665.15832 Manual De Uso Y Cuidado

Use this cycle for china
and crystal. This cycle
uses a light wash and
gentle dry. During the
heated dry, the heating
element cycles on and off.
Initial display time: 68 min
Soil Wash Rinse Main
Level Wash
Sensed
Heavy
Light
Use this cycle for pre-
rinsed or lightly-soiled
loads. The sensor adds
water and time, if needed,
for maximum cleaning.
No drying options are
available for this cycle.
Initial display time: 26 min
Soil Wash Rinse Main
Level Wash
Sensed
Heavy
Light
Use this rinse cycle for
rinsing dishes, glasses,
and silverware that will
not be washed right away.
Initial display time: 10 min
Soil Wash Rinse Main
Level Wash
Sensed
Heavy
Light
NOTE: The sensor in your dishwasher monitors the soil level.
Cycle time and/or water usage can vary from the numbers above
as the sensor adjusts the cycle for the best wash performance.
14
Use
covered
detergent
dispenser
section.
Rinse Final Dry Cycle
or Heated Time
Purge Rinse (min)
72*
130°F
cycled
(54°C)
58*
130°F
cycled
(54°C)
Use
covered
detergent
dispenser
section.
Purge Final Dry Cycle
Heated Time
Rinse (min)
30*
140°F
(60°C)
26*
140°F
(60°C)
Do not use
detergent
with this
cycle.
Rinse Final Dry Cycle
Heated Time
Rinse (min)
14
10
Anytime during a cycle, press
Water
The dishwasher pauses for about 5 seconds. Then the
Usage
display shows
(gal/L)
8.6/32.7
4.8/18.2
Your dishwasher starts a 2 minute drain (if needed). Let the
dishwasher drain completely. The light turns off after 2
minutes.
NOTE: If your dishwasher does not need draining, the light turns
off. Select a new cycle and options.
To stop the drain
You can press Cancel/Drain again to stop the drain immediately.
Remember to drain the dishwasher before starting a new cycle.
NOTE: A small amount of water remains in the dishwasher. This
is normal.
To clear the indicators
Water
Press Cancel/Drain before starting the dishwasher to clear all
Usage
options and cycles.
(gal/L)
6.9/26.1

Changing a Cycle or Setting

4.8/18.2
During the first fill of a cycle
1. Press a new cycle and/or options.
2. Check the detergent dispensers. They must be filled properly
for the new cycle.
After the first fill of a cycle
1. Press
Water
The display shows
Usage
(gal/L)
4.3/16.4
2.2/8.2
Your dishwasher starts a 2 minute drain (if needed). Let the
dishwasher drain completely. The light turns off after 2
minutes.
NOTE: If your dishwasher does not need draining, the light
turns off.
2. Check the detergent dispensers. They must be filled properly
for the new cycle.
3. Close the door.
4. Press a new cycle and/or options.
5. Press START.

Canceling a Cycle