Publicidad
Idiomas disponibles
Idiomas disponibles
17. Parallel fence ruler
18. Zero mark
19. Parallel fence
20. Guide rod
21. Depth stop revolver
22. Screws
23. Template guide
24. Dust adapter
25. Dust tube
2. SAFETY INSTRUCTIONS
The following symbols are used in these
instructions for use:
Read the instructions carefully.
Danger of life and risk of injury as well
as risk of damage to the machine in
case of non-adherence to the safety
instructions in these instructions of use.
Danger of electric shock.
Remove the plug from the mains socket.
Variable speed control.
Wear ear and eye protection.
Wear a dust mask.
Wear protection gloves.
Additional safety instructions
•
Please check workpieces for any obstructions
on the surface of the material, such as
protruding nails etc., to protect the router
head.
•
Wait until the router has come to a complete
stop before removing any blocked or routed
material around the cutter. Use a long stick for
this and never your finger.
•
Please keep your hands away from the routing
surface.
•
Immediately switch off the tool if it starts
producing any unusual noise or starts vibrating
excessively.
•
Please check that all parts are secure, tools
are removed etc. before operation.
Always check that the power supply
corresponds to the voltage on the rating
plate.
Your machine is double insulated,
therefore no earthwire is required.
•
Immediately throw away old cables or plugs
when they have been replaced by new ones. It
is dangerous to insert the plug of a loose cable
in the wall outlet.
•
Only use an approved extension cable suitable
for the power input of the machine. The minimum
conductor size is 1.5 mm
reel always unwind the reel completely.
Prior to mounting an accessory always
unplug the tool.
Wait until the machine has come to a
complete standstill and the cutter has
cooled down before replacing a cutter.
3. ASSEMBLY
Router Bit Selection
Depending on processing and application, router
bits are available in the most different designs
and qualities:
Router bits made of high speed steel (HSS) are
suitable for working with soft materials, e. g. soft
wood and plastic.
Carbide tipped router bits (HM) are particularly
suitable for hard and abrasive materials, e. g.
hard wood and aluminium.
Mounting and removing cutters
Fig. C
Only use cutters with a shaft diameter which
corresponds with the size of the collet. Only use
cutters which are suited for the maximum speed
of the machine. The cutter diameter should not
exceed the maximum diameter (see 'Technical
specifications').
. When using a cable
2
5
Publicidad
