Battery Handling; Battery; Transport And Storage; Disposal Of The Battery, Battery Charger And Machine - Husqvarna LC 146S Manual De Instrucciones

Battery (LC 146SPE)
General
WARNING! Risk of electric shock and
!
short circuiting. Use approved and intact
wall sockets. Make sure that the cable is
not damaged. Replace cable if it appears
to be damaged in any way.
The battery must be charged before using it the first time.
Regularly check that the battery charger and the battery
are intact.
Bear in mind that:
• Charge the battery using the battery charger supplied.
• The charger must be connected to a grounded outlet
socket.
• Charge the battery for max. 24 hours.
• Do not charge the battery in direct sunlight.
• Do not charge at temperatures below +5° C.
• The machine must be charged in a dry and well-
ventilated area, protected from water, damp, oil and
grease.
• Never charge the machine in the vicinity of flammable
substances or gases.
Charging the battery
• Connect the battery charger to the voltage and
frequency specified on the rating plate.
• Put the electric plug in a earthed socket-outlet.
• Open the cover on the electric starter
• Connect the battery charger and charge the battery
for max. 24 hours.
• Pull out the plug. Never jerk the power supply cable to
disconnect it from the wall socket.

BATTERY HANDLING

Transport and storage

•
•
•
•
•
•
•
•
•
•
Disposal of the battery, battery
charger and machine
Symbols on the product or its packaging indicate that this
product cannot be handled as domestic waste. It must
instead be submitted to an appropriate recycling station
for the recovery of electrical and electronic equipment.
By ensuring that this product is taken care of correctly,
you can help to counteract the potential negative impact
on the environment and people that can otherwise result
through the incorrect waste management of this product.
For more detailed information about recycling this
product, contact your municipality, your domestic waste
service or the shop from where you purchased the
product.
For commercial transports e.g. by third parties,
forwarding agents, special requirement on packing
and labeling must be observed.
For preparation of the item being shipped, consulting
an expert for hazardous material is required. Please
also observe possibly more detailed national
regulations.
Tape or mask off open contacts and pack up the
batteriy in such a manner that it cannot move around
in the packing.
Secure the machine during transport.
Always remove the battery for storage or transport.
Store the battery and the battery charger in a dry,
moisture-free and frost-free space.
Do not store the battery in places where static
electricity can occur. Never store the battery in a metal
box.
Store the battery and the battery charger where the
temperature is between 5 °C and 45 °C and never in
direct sunlight.
Store the battery charger only in an enclosed and dry
space. Store the equipment in a lockable area so that
it is out of reach of children and unauthorized persons.
Ensure the machine is cleaned and that a complete
service is carried out before long-term storage.
–
English 69