Final Steps - Bosch SRV53C Manual De Uso Y Cuidado

Top Mount
Figure 14
Side Mount
Figure 15
Dishwasher Placement

FINAL STEPS

• Installing the Mounting Brackets
• Sliding the dishwasher into place
• Leveling the dishwasher
• Securing the unit
• Attaching the toe panel
When any covers are removed or the dishwasher
is out of the cabinet, electrical power and sharp
edges or points may be exposed.
Installing the Countertop Mounting Brackets
Before installing the supplied countertop mounting
brackets, decide which method of securing the
dishwasher into its enclosure will be used. Once
the mounting brackets are installed on the dish-
washer, removing them is difficult and will damage
the mounting brackets and the dishwasher.
The dishwasher can be secured into its enclosure in two
ways:
1 Top Mount is used for countertops made of wood or
other materials that can easily drilled. Orient the
mounting brackets as shown in Figure 14, and posi-
tion the two small tabs on the mounting brackets over
the two slots on the dishwasher's front corners. Push
the mounting brackets down firmly to insert the tabs
into the slots.
2 Side Mount is used for countertops made of marble,
granite, or other very hard materials that cannot be
easily drilled. Bend the mounting brackets along the
small holes and in the same direction as the two small
tabs. Orient the mounting brackets as shown in Figure
15, and position the two small tabs on the mounting
brackets over the two slots on the dishwasher's front
corners. Push the mounting brackets down firmly to
insert the tabs into the slots.
Do not use the dishwasher until it is completely
installed. When opening the door on an
uninstalled dishwasher, carefully open the door
while supporting the rear of the unit. Failure to
follow this warning can result in serious injury.
CAUTION
WARNING
Avoid Tip Over Hazard
11