Urrea PP921A Manual De Usuario página 17

vice. Never attempt to bypass its operations.
START AND STOP THE ENGINE
WARNING: the blade begins to rotate
As soon as the engine is started.
IMPORTANT: Do not operate the machine in
enclosed or poorly.
Ventilated areas as the exhaust gas contains
toxic substance.
Keep hands, feet ,hair and clothing away from
All the moving parts of the machine. The ex-
haust and other parts of the machine will be-
come hot during use.
Make sure that the blade is securely fastened
before.
Starting the engine.
IMPORTANT: To start the engine, make sure
that the spark. Lug boot is located on the plug
and the machine is filled with sufficient oil and
petrol.
TO START THE ENGINE
1. When starting a cold engine, press down the
primer fully 3-5 times.(For lawn mower with BS
engine need to put the throttle control lever on
the START position before starting ).
WARNING: Too much presses on primer May
cause engine flooded When starting a warm
Engine, the primer does not need to be used.
If the engine stops due to a lack of petrol, refill
and press Down the primer 3-5 times.
2. Stand behind the mower. Pull the engine
Start/stop lever toward upper handle with one
hand . And Place the other hand on the starter
handle.
3. Pull the starter handle out approx .. 10-15cm
Until you feel a resistance and then start the
engine with a sharp pull.
IMPORTANT: If the engine fails to start after
three pulls, repeat the process .
4. Once the engine is running, put the starter
rope into the rope guide.
TO STOP THE ENGINE
Release the engine start/stop lever, it will return
to its Initial position, the engine will automati-
cally switches off.
ONE PUSH START AND VARIABLE SPEED
E N G L I S H •
FUNCTION
1. Charge the battery for 3 hours before use.
2. Pull the Brake lever back to the handle.
3. Push button to start engine ..
4. Once engine is running, select drive speed 1,
2 or 3.
5. Standing behind the machine, move drive le-
ver towards main handle and machine will move
forward to cut grass.
6. Releasing the brake lever will stop the lawn
mower.
TO CLEAN A FLOODED ENGINE
IMPORTANT: If the engine won't start after
you have Operated the starter a several times,
the engine may be flood with excess fuel . Use
following procedure to clear and start a flooded
engine.
1. Release the engine start/stop lever to stop
engine.
2. Remove the spark plug, dry it, and then re-
install it.
IMPORTANT: Install the spark plug carefully
by hand, to avoid cross-threading. After the
plug is seated tighten 1/8 to 1 /4 turn with socket
spanner of spark plug to compress the washer.
1. Pull the engine start/stop lever toward upper
handle.
2. Operate the starter as described above
USING THE SELF- PROPELLED FUNCTION
This unit equipped with self-propelled system .
If you press the drive lever(clutch lever), the
clutch for the drive will be closed and the lawn
mower will start to move with the engine run-
ning .
To stop the moving lawn mower, just simply re-
lease the drive lever in good time.
MOWING
WARNING: Always observe the strictest
safety procedures when using the lawn mower.
Carefully read the safety instructions of this
manual before using the lawn mower.
WARNING: Never open the ejector flap
when the grass bag has been detached (to be
emptied) and the engine is still running. The
rotating blade can cause serious injuries!
1. Select your required setting.
2. Start the engine and allow it run, and set it to
required speed. See "to start the engine".
3.Keep a firm grip on the upper handle with
Us er 's M an u a l
17