To Do A General Inspection; To Clean The Product; To Clean The Battery And The Battery Charger; To Examine The Cutting Equipment - Husqvarna LC 247iX Manual De Usuario

Do a check of the motor brake handle *
Make sure that the ON/OFF button operates correctly and is not defective
Examine the battery for damage
Do a check of the battery charge
Make sure that the release buttons on the battery operates correctly and that the
battery locks into the product
Examine the battery charger for damage and make sure that it operates correct-
ly.
Examine the connections between the battery and the product. Also examine the
connection between the battery and the battery charger.

To do a general inspection

• Make sure that the nuts and screws on the product
are tightened.
• Make sure that the cables on the product are not in a
position where they can get damaged.

To clean the product

• Clean plastic parts with a clean and dry cloth.
• Do not use water to clean the product. Water can
enter the battery or the motor and cause short circuit
or damage to the product.
• Do not use a high pressure washer to clean the
product.
• Do not flush water directly on the motor.
• Use a brush to remove leaves, grass and dirt.
To clean the battery and the battery
charger
CAUTION: Do not clean the battery or the
battery charger with water.
• Make sure that the battery and the battery charger
are clean and dry before you put the battery into the
battery charger.
• Clean the battery terminals with compressed air or
use a soft and dry cloth.
• Clean the surfaces of the battery and the battery
charger with a soft and dry cloth.

To examine the cutting equipment

WARNING: To prevent accidental start, turn
the safety key to 0, remove the battery and
wait a minimum 5 seconds.
890 - 002 - 21.12.2018
WARNING: Use protective gloves when you
do maintenance on the cutting equipment.
The blade is very sharp and cuts can easily
occur.
1. Examine the cutting equipment for damage or
cracks. Always replace a damaged cutting
equipment.
2. Look at the blade to see if it is damaged or blunt.
Note: It is necessary to balance the blade after it is
sharpened. Let a service center sharpen, replace and
balance the blade. If you hit an obstacle that causes the
product to stop, replace the damaged blade. Let the
service center estimate if the blade can be sharpened or
must be replaced.

To remove and replace the blade

1. Lock the blade with a block of wood. (Fig. 45)
2. Remove the blade bolt.
3. Remove the blade.
4. Examine the blade support and blade bolt to see if
there are damages.
5. Examine the motor shaft to make sure that it is not
bent.
6. When you attach the new blade, point the angled
ends of the blade in the direction of the cutting cover.
(Fig. 46)
7. Make sure that the blade is aligned with the center of
the motor shaft.
8. Lock the blade with a block of wood. Attach the
spring washer and tighten the bolt and washer with a
torque of 23–28 Nm. (Fig. 47)
9. Pull the blade around by hand and make sure that it
turns freely.
Each
Monthly
use season
X
X
X
X
X
X
Each
X
19