To Get A Good Result; To Stop The Product; Maintenance; Maintenance Schedule - Husqvarna LB 146P Manual De Usuario

Ocultar thumbs Ver también para LB 146P:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 76
Electrical start (LB 246PI)
1. Make sure that the battery is activated and charged.
To start the battery on page 12 .
See
2. Attach the battery to the engine. (Fig. 30)
3. Push the start inhibitor out to the right (A).
4. Pull the start bar (B) against the handlebar to start
the starter motor. The starter motor stops when the
engine starts. (Fig. 31)

To stop the product

To stop the engine, release the engine brake handle.
To remove the battery
To prevent accidental start of the engine, remove the
battery on model LB 246PI when the product is not in
operation.
Introduction
WARNING: Before you do maintenance, you
must read and understand the safety
chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.

Maintenance schedule

WARNING: When you tilt the product, make
sure that the air filter is up at the top of the
tilted product, and not against the ground.

Maintenance

Do a general inspection
Examine the oil level
Clean the product
Examine the cutting equipment
Examine the cutting cover*
Examine the engine brake handle*
Examine the battery*
Examine the muffler*
Examine the spark plug
Change the oil (the first time after 5 h use, then after each 50 h use)
Change the air filter (after 50 h use)
10
1. Press the lock buttons (A) and pull the battery out.
(Fig. 32)

To get a good result

Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
level. If the grass is very long, drive slowly and cut 2
times if necessary.
Cut in different directions each time to prevent
stripes in the lawn.
Maintenance
The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with * see instructions in
Safety devices on the product on page 7 .
CAUTION: For model LB 246PI, always
remove the battery before you do
maintenance, repairs or clean the product.
Daily
Weekly
X
X
X
X
X
X
X
X
X
Monthly
X
X
287 - 006 -

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Lb 246pi

Tabla de contenido