en
For your safety
Children shall not play with the appliance. Cleaning and user
maintenance must not be performed by children unless they are
supervised.
Do not leave the running appliance unattended. Connect and
operate the appliance only in accordance with the specifications on
the rating plate. Only use the appliance indoors at room temperature
and up to 2000 m above sea level.
Always disconnect the appliance from the supply if it is left unat-
tended and before assembling, disassembling or cleaning.
Do not place the power cord over sharp edges or hot surfaces.
Do not use the appliance if the power cord and/or appliance are
damaged. To prevent injury, a damaged power cord must be
replaced by the manufacturer or his customer service or a simi-
larly qualified person. Only our customer service may repair the
appliance.
Safety instructions for this appliance
W Risk of injury!
W Risk of electric shock!
Do not insert the mains plug until all preparations for working with
the appliance are complete. When the appliance is not in use, pull
out the mains plug. Before eliminating a fault, pull out the mains
plug. Never immerse the base unit in liquid or hold under running
water. Do not use a steam cleaner. Use only the rotary switch to
switch the appliance on or off.
W Risk of injury from the rotating tools!
Before replacing accessories or additional parts, which move during
operation, switch off the appliance and disconnect from the power
supply. When the appliance is switched off, the drive continues
running briefly and stops in the tool change position. Do not adjust
the swivel arm while the appliance is switched on. Wait until the
drive has come to a standstill.
Keep hands clear of rotating parts. While the appliance is operating,
never place fingers in the mixing bowl. Do not reach into the feed
tube. Do not operate the appliance without the lid.
For reasons of safety the appliance cannot be operated unless
unused drives are covered with drive guards.
W Risk of injury from sharp blades!
Do not grip the sharp blades or edges of the cutting discs. Take hold
of cutting discs by the edge only. Do not touch blender blades with
bare hands.
18
124_MUM58xxx_8001027214.indb 18
27.11.2015 15:11:45