Cutting Warped Material - RIDGID R4122 Manual Del Operador

OPERATION

CUTTING WARPED MATERIAL

See Figures 38 - 39.
When cutting warped material, always make sure it is
positioned on the miter table with the convex side against
the fence as shown in figure 38.
If the warped material is positioned the wrong way as shown
in figure 39, it will pinch the blade near the completion of
the cut.
RIGHT
WARNING:
To avoid a kickback and to avoid serious personal
injury, never position the concave edge of bowed
or warped material against the fence.
Fig. 38
29 - English
WRONG
Fig. 39