Keep this document for future reference.
The correct installation of this appliance is your responsibility, we strongly recommend you to have a qualified
technician or Whirlpool Service Technician to install your new range.
Check the local regulations. Make sure there is power supply available. See section Electrical Requirements.
Recommendations
It's the installer's responsibility to fulfill with the spaces specified in this manual.
The location of the range should be away from the elements and over a flat resistant surface.
Don't install your range over a carpet or any flammable material. If the ground under the range is synthetic, make sure it
withstand at least 95°C without damage.
Keep the areas surrounding the range free from gasoline and other flammable liquids and vapors.
Don´t get to close from the flames on the burners, don't use loose clothing when operating the cooktop.
Provide the correct maintenance to the appliance.
Use this range for household use only, this is not a commercial appliance.
If you need to move your range, don't lift or take it from the handles. Always open the oven door, lift from the upper part
of the cavity and move.
"THIS APPLIANCE SHOULD NOT BE INSTALLED IN BATHROOMS OR BEDROOMS"
Installation
Remove the adhesive tape and packaging materials.
Identify and separate all the parts of the appliance.
The best location for your new range should be in a place protected from wind flow and with enough space to open the
door oven.
Don't install cabinets or other furniture over the range.
If hood will be installed, make sure it is at least 61 cm from the range.
If the range has accessories that need a power supply, make sure the installation is close from a wall outlet.
Location Requirements
Minimum spaces for installation (these spaces should be followed)
A.18"
B.13"
C.30"
D.24"
E.30 1/8"
Gas Supply Requirements
This stove is prepared to work with a moving LP gas tank or a fixed LP gas tank.
09-May-2014 18:21:12 EDT | RELEASED
Range Installation
ALL ELECTRICAL WORK MUST BE DONE BY A QUALIFIED ELECTRICIAN.
Risk of injury due to overweight
Use two or more people to move and install your product.
Failure to do so may cause damage to your spine or injured.
In some European factories the letter "W" of the part code mentioned herein will be automatically
WARNING
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
19