Screen Clip Assembly - AMQ KINEX Guia De Instalacion

ACCESSORY | Screen Clip Assembly
1
Step 1
Remove beam screen clip hole cover .
Step 2
Screw in M6*10 screen clip screw into position . Do
not tighten fully, leave about 4mm clearance .
Step 3
Insert screen clip into position . Slide screen clip
into position to secure it, then tighten screw fully .
Step 4
Position screen in the middle and drop it into clip .
Step 5
Position the worksurface to have at least 1'' gap
between worksurface and screen clip .
KINEX INSTALLATION GUIDE | 34
3
2
Do not tighten fully,
leave 4mm gap.
KINEX DOUBLE RUN
3 3
4
5
1" 1"
amqsolutions.com