Led Light Displays For Warnings And Error Messages - Leister FUSION 1 Instrucciones De Servicio

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Warning
Warning
Warning

9.2 LED light displays for warnings and error messages

Message type
Status display
Status display
Error
32
LED light
Off
On
2 x per second
The drive for output regulation is not reaching the setpoint
speed. Heating-up phase is extended by 2 minutes.
Service message: The drive motor for output regulation has
been working for over 300 operating hours. Press the drive
(15) switch to reject this message and stop the work that is
due to take place. The drive carbon brushes should initially be
replaced by your Service Center.
Service message: The blower motor has been working for
over 1,000 operating hours. Press the drive (15) switch to
reject this message and stop the work that is due to take
place. The blower carbon brushes should initially be replaced
by your Service Center.
Description and measures
Cool down, heating switched off, FUSION 1 not ready for
operation
Device is ready for operation
Blower error
Carbon brushes worn down *
Blower blocked
* Contact Leister Service Center
Drive error:
Drive overload, switch off FUSION 1, disconnect power
plug, allow to cool down, and try again with a higher
prewarming temperature
Voltage supply error
Line voltage > 20% -> heating overtemperature
Line frequency < 15 Hz or > 100 Hz

Publicidad

Tabla de contenido
loading

Tabla de contenido