User Maintenance Instructions - BaByliss PRO FOILFX 01 Manual Del Usaurio

9. Always purchase the correct size and grade of battery most suitable for the
intended use.
10. Replace all batteries of a set at the same time.
11. Do not mix old and new batteries. Do not mix alkaline, standard (carbon-
zinc), or rechargeable (nickel cadmium or nickel metal hydride) batteries.
ON/OFF SWITCH
To operate, simply slide switch to the ON (I) position. To stop operation, set to
the OFF (0) position.
VERY IMPORTANT: Blades must be cleaned and oiled on a regular basis
for proper functioning. Failure to regularly clean and oil the blades will
void the warranty.
BASIC INSTRUCTIONS FOR USE
1. Men whose skin is sensitive or easily irritated by shaving, or who suffer
from a skin allergy, should test one section on the leg or arm before using
the shaver.
2. Remove the protective cover and turn on the unit to start shaving. Hold
the shaver at a right angle to the area of your face that you want to shave
and run the single shaving foil carefully along your skin. Tip: In general, we
recommend that you shave against the direction of hair growth, as this is the
best way to trim the hair. Pull your skin tight, with your fingers in inaccessible
areas, to achieve optimum results.
3. Switch the shaver off each time after shaving and clean it.
4. Do not push the shaver on the skin too hard as it could cause irritation, make
the shaver warm and prevent a perfect shave.
5. Please note that it takes 2 to 4 weeks for your skin to adapt to a shaver, so
please do not change shaving instruments in this period of time.
6. If hair is longer than 1/32" begin by cutting the hair down first with a trimmer,
then use shaver for a smooth close finish.
FXFS1 IB-15501.indd 5-6
USER MAINTENANCE
INSTRUCTIONS
TAKING CARE OF YOUR SHAVER
Do not remove the shaving foil unit while the shaver is switched on. Always
switch the shaver off!
Ensure that no water gets into the inside of the shaver to avoid the risk of an
electric shock when it is back in operation.
Never press on the cutting blades or the shaving foil and do not touch them
with hard objects as this can cause irreparable damage to the shaver or parts.
Be careful when dealing with the blades, as they are very sharp. Risk of injury!
When cleaning, do not apply any detergents or scouring agents and do not
use any abrasive or sharp objects. They can cause irreparable damage to the
shaver.
NOTE: When cleaning your shaver, make sure the unit is turned off.
CAUTION!
• DO NOT run shaver or cutters under water. Use only the small brush (included)
to clean.
• To clean the external surfaces of the shaver, use a damp cloth. Do not use
strong detergents or other chemicals.
• To dry, wipe the surface of the shaver with a dry towel. Do not use a hair dryer
or heater to dry the shaver.
• The shaver should not be used until it has completely dried.
TO REPLACE FOIL HEAD ASSEMBLY
1. Remove the foil head assembly by pressing the round release button located
on the side of the shaver. Hold the foil head assembly on both sides and
lightly pull away from shaver unit.
2. Take the replacement foil head assembly (FXRF1) out of package. Align
the replacement foil head assembly over the cutters. Carefully move the
replacement foil head assembly down towards the shaver unit until it firmly
snaps into place. BE CAREFUL NOT TO DAMAGE THE FOIL OR CUTTERS
WHILE INSTALLING.
3/21/18 11:54 AM