User Maintenance Instructions - BaByliss PRO 4ARTISTS FXFS1E Manual Del Usuario

leg or arm before using the sha-
ver.
2. Remove the protective cover and
turn on the unit to start shaving.
Hold the shaver at a right angle
to the area of your face that you
want to shave and run the single
shaving foil carefully along your
skin. Tip: In general, we recom-
mend that you shave against the
direction of hair growth, as this is
the best way to trim the hair. Pull
your skin tight, with your fingers
in inaccessible areas, to achieve
optimum results.
3. Switch the shaver off each time
after shaving and clean it.
4. Do not push the shaver on the
skin too hard as it could cause
irritation, make the shaver warm
and prevent a perfect shave.
5. Please note that it takes 2 to 4
weeks for your skin to adapt to a
shaver, so please do not change
shaving instruments in this pe-
riod of time.
6. If hair is longer than 1 mm begin
by cutting the hair down first
with a trimmer, then use shaver
for a smooth close finish.
USER MAINTENANCE
INSTRUCTIONS
TAKING CARE OF YOUR SHAVER
Do not remove the shaving foil
unit while the shaver is switched
on. Always switch the shaver off!
Ensure that no water gets into the
inside of the shaver to avoid the
risk of an electric shock when it is
back in operation.
Never press on the cutting blades
or the shaving foil and do not
touch them with hard objects as
this can cause irreparable damage
to the shaver or parts.
Be careful when dealing with the
blades, as they are very sharp. Risk
of injury!
When cleaning, do not apply any
detergents or scouring agents and
do not use any abrasive or sharp
objects. They can cause irrepa-
rable damage to the shaver.
NOTE: When cleaning your shaver,
make sure the unit is turned off.
CAUTION!
• DO NOT run shaver or cutters
under water. Use only the small
brush (included) to clean.
• To clean the external surfaces
of the shaver, use a damp cloth.
Do not use strong detergents or
other chemicals.
• To dry, wipe the surface of the
shaver with a dry towel. Do not
use a hair dryer or heater to dry
the shaver.
• The shaver should not be used
until it has completely dried.
TO REPLACE FOIL HEAD
ASSEMBLY
1. Remove the foil head assembly
by pressing the round release
button located on the side of the
shaver. Hold the foil head assem-
bly on both sides and lightly pull
away from shaver unit.
2. Take the
8
replacement foil