Personal Safety; Especific Safety Rules - ENAR AFE 2000 P Manual De Instrucciones

CHECK with a qualified electrician if you are in doubt as to whether the outlet is properly grounded.
AVOID body contact with grounded surfaces such as pipes, radiators, ranges and refrigerators.
DO NOT EXPOSE power tools to rain or wet conditions.
DO NOT ABUSE the cord.
NEVER USE the cord to carry the tools or the plug from an outlet.
KEEP cord away from heat, oil, sharp edges or moving parts.
REPLACE damaged cords immediately. Damaged cords increase the risk of electric shock.
WHEN OPERATING a power tool outside, use an outdoor extension cord marked "W-A", "W" or
"H07RN-F".

3.3 PERSONAL SAFETY

STAY ALERT, watch what you are doing and use common sense when operating a power tool.
DO NOT USE TOOL while tired or under the influence of drugs, alcohol, or medication.
DRESS PROPERLY.
DO NOT WEAR loose clothing or jewellery.
CONTAIN long hair. KEEP your hair, clothing, and gloves away from moving parts.
AVOID accidental starting.
BE SURE switch is off before plugging in.
REMOVE adjusting keys or switches before turning the tool on.
DO NOT overreach.
KEEP proper footing and balance at all times.
USE safety equipment.
Always WEAR eye protection.
3.4 TOOL USE AND CARE
USE clamps or other practical way to secure and support the work piece to a stable platform.
DO NOT FORCE tool.
USE the correct tool for your application.
DO NOT USE tool if switch does not turn it on or off.
DISCONNECT the plug from the power source before making any adjustments, changing
accessories, or storing the tool.
STORE idle tools out of reach of children and other untrained persons.
MAINTAIN tool with care.
CHECK for misalignment or binding of moving parts, breakage of parts, and any other condition that
may affect the tools operation. If damaged, have the tool serviced before using.
USE only accessories that are recommended by the manufacturer for your model.
3.5 SERVICE
Tool service MUST BE PERFORMED only by qualified repair personnel.
When servicing a tool, USE only identical replacement parts.
FOLLOW instructions in the Maintenance section of this manual.

3.6 ESPECIFIC SAFETY RULES

For the proper operation of the converter, MAKE SURE that operators have been instructed in the
proper management of this machine.
The converter SHOULD ONLY BE USED in the specific jobs for with it the help of this manual.
Before connecting the converter to the electrical system, MAKE SURE that the voltage and
frequency coincide with the ones stated in the characteristics equipment plate, located in the top part
of the plastic housing.
ENSURE that all frame screws are tight before starting work.
The motor plug should not be used to start or stop the equipment.
The electrical feeding cable should not be used to remove the plug from the socket.
Protect the electrical feeding cable against heat, oil or sharp edges.
DO NOT WORK CLOSE to flammable liquids or in areas exposed to flammable gases.
FRECUENCY CONVERTERS
AFG, AFD, AFE
en
7