Milwaukee 2790-20 Manual Del Operador página 6

Setting the Clock
1. Press and hold the CLOCK button until the hour
begins to flash.
2. Use the buttons to change the hour.
3. Press the CLOCK button again. Use the
to change the minutes.
4. Press the CLOCK button again to save.
EQ Adjustment
To manually adjust the Bass/Treble sound, press
the EQ button. Set the bass sound using the
buttons. Press the EQ button again to set the treble
sound, using the
Selecting Band
Push the MODE button to select AM, FM, or AUX.
Tuning (Seeking and Scanning)
Press and hold the
the band. When a station is found, the SEEK will
stop. Use the SCAN button to continue through the
stations, pausing at each.
PRESET Stations
To set the PRESET stations:
1. Tune to desired station.
2. Press and hold the PRESET button until the
PRESET indicator on the display begins to flash.
3. Use the buttons to select the PRESET
location for the station. Ten locations (0-9) are
available.
4. Press the PRESET button to save the location.
To tune to a PRESET station:
Press and release the PRESET button to step
through the PRESET stations.
Using the Stereo AUX Jack
1. Open the Battery/Auxiliary Compartment
2. Plug the auxiliary device into the Stereo AUX
jack.
3. Use the MODE button to select AUX.
4. Start the auxiliary device.
buttons.
buttons to SEEK through
mainTenance
Warning
always unplug the charger and remove the
battery pack from the charger or tool before
performing any maintenance. Never disas-
semble the tool, battery pack or charger.
Contact a milWaukee service facility for
ALL repairs.
Maintaining Tool
Keep your tool, battery pack and charger in good
repair by adopting a regular maintenance program.
If the tool does not start or operate at full power
with a fully charged battery pack, clean the contacts
on the battery pack. If the tool still does not work
properly, return the tool, charger and battery pack,
to a MILWAUKEE service facility for repairs.
Warning
sonal injury and damage, never immerse your
tool, battery pack or charger in liquid or allow
a liquid to flow inside them.
Cleaning
Clean dust and debris from charger and tool
vents. Keep tool handles clean, dry and free of oil
or grease. Use only mild soap and a damp cloth
to clean the tool, battery pack and charger since
certain cleaning agents and solvents are harmful to
plastics and other insulated parts. Some of these
include gasoline, turpentine, lacquer thinner, paint
thinner, chlorinated cleaning solvents, ammonia
and household detergents containing ammonia.
Never use flammable or combustible solvents
around tools.
Repairs
For repairs, return the tool, battery pack and char-
ger to the nearest service center listed on the back
cover of this operator's manual.
accessories
Warning
pack before changing or removing acces-
sories. Only use accessories specifically
recommended for this tool. Others may be
hazardous.
For a complete listing of accessories refer to your
MILWAUKEE Electric Tool catalog or go online
to www.milwaukeetool.com. To obtain a catalog,
contact your local distributor or a service center.
6
To reduce the risk of injury,
To reduce the risk of per-
Always remove battery