Perel AOBD2 Manual Del Usuario página 4

4. Turn on the ignition but do not start the car.
5. Press ENTER. A sequence of messages showing the OBD protocols may be observed on the display until the
vehicle protocol is detected.
Note that not all the above messages will necessarily be observed.
If a LINK ERROR message is displayed, turn off the ignition for about 10 seconds, check if the code reader
is securely connected and turn the ignition back on. Repeat from step 5.
If the error message reappears, check if the vehicle is compatible with the code reader.
6. Wait for the main menu to be displayed. Select DTC by pressing ENTER.
If there are no Diagnostic Trouble Codes (DTCs) retrieved the display will indicate NO CODES.
If there are any DTCs, the total number of the Fault Codes followed by that of the Pending Codes will be
displayed.
7. Read the DTCs by pressing SCROLL. The first code number will be displayed on the first line, the numerical
sequence of the code and the total number of the codes stored will be displayed on the second line. To view
additional codes, press SCROLL until all codes have been displayed.
V. 01 – 07/02/2017
AOBD2
4 ©Velleman nv