Amann Girrbach Hand Scanner & IntelliCode Instrucciones De Uso página 18

O P E R AT I N G I N S T R U C T I O N S
3.4 Find blanks again that have already been created in the CAM software
EN
Fig. 15
Fig. 16
Fig. 17
18
Open the CAM software and click in the field
with the cursor
#
The message that the product code already
exists appears in the software when scanning
the code on the blank label (Fig. 16).
The blank already created can now be loaded
!
using the "Load" button. (Fig. 17)
Note: The same message would appear
if the code on the packaging label had been
scanned, if still available.
(Fig. 15)
#