Software Installation - Velleman CAMIP10 Manual Del Usuario

6. Hardware installation and operation
• Choose a location for the camera, keeping following guidelines in mind:
• Do not install the camera in locations where extremely high or low temperatures or excessive
vibrations may occur.
• Avoid mounting the camera near high electro-magnetic fields.
• Do not aim the camera at the sun or other extremely bright objects.
• Attach the mounting bracket [8] to the wall or ceiling using the 3 included screws. Place the
CAMIP10 on top and secure it with the centre screw [15]. Determine the desired angle and
tighten the joint screws.
• Connect the antenna [1] to the antenna connector [11] and/or connect a network cable (included)
to the RJ45 jack [9].
Note: it is possible to connect the camera straight to the RJ45 port of a computer. In this case a
crossed cable (not incl.) should be used and network settings must be configured manually.
• Plug the DC connector of the power adaptor into the 5VDC input jack [10]. Only use the included
adaptor or one with the same specifications.
• Plug the adaptor into a suitable mains outlet (100~240V AC/50~60Hz).
Notes:
• It takes about 30s for the camera to initialise.
• When the image appears out of focus, turn the lens [5] to adjust.

7. Software installation

• Insert the included CD-ROM into a suitable computer system (not incl.).
System requirements: CPU ≥ 2.0 GHz / memory ≥ 256MB / network ≥ 10 MB / video card ≥
64MB memory / recommended OS: Windows 2000, XP, Vista, 7 or Mac.
Windows
• Locate the software installer IPCamSetup.exe and double click it.
• Follow the instructions on the screen. Click Next to start the software installation.
16.12.2011
CAMIP10
4
©Velleman nv