H+H babyruf MBF 8181 Manual De Instrucciones página 20

Note:
Before using the parent unit for the first time, charge NiMH battery with the rapid
charger for at least four hours. Be sure to switch off the unit before charging.
Caution: Before connecting the parent unit with the rapid charger:
1) Ensure that a rechargeable battery is installed. Otherwise, there is a risk of explosion.
2) Ensure that the battery is inserted in the unit correctly. Otherwise, the parent unit cannot
operate properly.
7. PAIRING
This process connects the receiver with the transmitter so that the units can communicate with
each other and no other devices (even a baby monitor of an identical model) can interfere with
the signal. On supply, the units are already paired with factory-preset code. However, we recom-
mend performing following steps for pairing again in order to achieve a higher level of privacy:
1. First press and hold the
2. Set the Power ON-OFF switch (15) to ON and wait until the temperature indicator (20) starts
flashing.
3. Now press and hold the
4. Set the Power ON-OFF switch (4) to ON and wait until the Tx indicator (8) starts flashing.
5. Release the
6. If pairing is successful, the Tx indicator (8) and the
stop flashing. At the same time, the parent unit will emit 2 beep sounds.
7. Switch both units off and on again; the baby monitor is now ready for operation.
8. In case the units cannot communicate with each other, repeat steps 1 - 7 again.
8. OPER ATION
8.1 BABY UNIT (TR ANSMIT TER)
1. Set the Power ON-OFF switch (4) to ON. The power indicator (9) lights up yellow.
2. Place the unit about 1 m from the crib with the microphone (5) facing towards the baby.
3. Adjust the microphone sensitivity by using the UP/DOWN buttons (2) and (3) so that the unit
is set to transmit whenever the microphone (5) detects sounds above a certain noise level.
The transmission indicator (8) flashes each time these buttons are pressed. The more frequent
the flashes, the higher the sensitivity of the microphone to any noise (max. 4 blinks and min.1
flash). Press
4. Once the unit is in transmit mode, the transmit indicator (8) lights up yellow. The unit returns
to standby mode a few seconds after the microphone (5) stops picking up any sound and the
20
button (14) on the parent unit.
button (3) on the baby unit.
button (3) and then press and hold the () button (3) again.
to increase and to reduce microphone sensitivity.
on the temperature indicator (20) should