Assembling And Adjustments; General; Mount Wall Mountings And Rail; Mount The Saw Carriage And Saw - Husqvarna WSC 40 Manual De Instrucciones

General

WARNING! Always disconnect the power
!
cable to the saw unit before installation,
cleaning and maintenance. Carelessness
can result in serious personal injury or
even death.

Mount wall mountings and rail

Assemble the system according to operator's manual for
actual wall saw.

Mount the saw carriage and saw

Assemble the system according to operator's manual for
actual wall saw.
Checking that the blade guard
guide is parallel with the blade
For alignment of the WSC 40 to the cut, make sure no
deformation has occured on the handle bar on the wall
saw.
1 Mount the blade guard guide on the guide and
measure between each of the end wheels and the
blade. The measurement between the outside of the
wheel guide and the blade shall be approximately 102
+/- 2 mm.
2 If the difference is larger than 2 mm, take away the
guide and adjust the frame with an iron bar to get the
guide parallel to the blade.
8 – English

ASSEMBLING AND ADJUSTMENTS

Mount the wall saw chain
attachment
IMPORTANT! Always keep the machine in the provided
box when not in use.
WARNING! Protect your hands with
!
gloves.
WARNING! Only one person should
!
perform the mounting procedure of the
machine to be able to prevent
unforeseen events.
WARNING! Risk of crush injuries! Hold
!
the machine steady.
IMPORTANT! Keep the floor clean during mounting.
Make sure that no objects are in the way.
1 Remove the blade and the blade flange according to
the operator's manual of the actual wall saw.
2 Make sure that the spindle hub is in the outer position.
It is not possible to attach WSC 40 if the hexagon shaft
is in the inner position.